Detector Battery - Minelab EQUINOX 600 Instruction Manual

Contents

Detector Battery

The EQUINOX detector is powered by an internal Lithium-ion battery.
Read 'Battery Charging Recommendations' on page 62
For instructions on how to charge the WM 08 Wireless Audio Module read
Wireless Headphones read page
Charging the Battery
Going detecting with a fully charged battery is
recommended. Typical battery runtime is
approximately 12 hours.
EQUINOX Series detectors are supplied with a USB charging cable
that features a snap-on magnetic connector.
1. Plug the supplied charging cable into any standard powered
USB-A port.
2. Connect the magnetic connector to the charging interface on
the rear of the EQUINOX control unit.
The green charge status LED on the top left of the control
panel will flash slowly.
3. When the battery is fully charged, the charge status LED will
remain on.
Charge Status LED
Charging (flashing)
Fully charged (on)
The charge time from completely flat to 100% is approximately 4
hours when a high capacity (>1.7A @ 5V) charger is used. Car and
wall charging accessories are available for separate purchase.
Any standard USB port compatible with USB battery charging 1.2
(BC1.2) can be used to charge your battery, however charge times
may be longer if using lower-power options.
If the detector is turned on during charging, the charge time will
be longer.
Disconnecting the Charger
The charging cable can be removed
from the charging interface by
pulling it sideways, or by pulling it
directly backwards.
57.
for important safety information.
page 55. For instructions on how to charge the ML 80
Battery Status Indicator
The battery status indicator shows the current battery level.
70% –100%
30% – 70%
<30%
<5% (Charging required)
When the battery level is critically low, 'bF' will appear on
the Target ID Display. The detector will then turn off
automatically.
The detector regulates the battery voltage so that its
performance remains constant regardless of the charge
remaining in the battery.
Battery Maintenance
Lithium-ion battery performance may degrade if unused for long
periods of time. Fully charge the battery at least once every 3–4
months to prevent this from occurring.
Even with correct care and maintenance, Lithium-ion battery
performance reduces over time with normal use. Therefore the
battery may need to be replaced every few years. Replacement
batteries can be supplied and installed by an Authorised Service
Centre.
Operating With a Power Bank
The detector must not be used underwater whilst
charging or when connected to a power bank.
You can use your EQUINOX detector whilst plugged into a portable
power bank. This means you can continue detecting even if the
detector battery is flat.
Connect the power bank to your detector using the supplied
EQUINOX USB charging cable, and continue detecting. You can
fasten it to the armrest stand via the armrest attachment points.
Detector Battery | 8