Wireless Headphones; Ml 105 Wireless Headphones; Re-Connect Previously Paired Headphones; The Wireless Audio Indicator - Minelab MANTICORE Instruction Manual

Wireless Headphones

ML 105 WIRELESS HEADPHONES

MANTICORE is supplied with Minelab ML 105 low‑latency
wireless headphones� ML 105 headphones can also be
used as wired headphones — see
page 64�
For detailed information on charging, pairing and other
controls, refer to the instructions supplied with the
headphones� The instructions can also be downloaded at
www�minelab�com/support/downloads/product‑manuals‑
guides�
PAIR WIRELESS HEADPHONES
1. Long‑press (2 seconds) the Wireless Side Button
( ) to initiate Wireless Pairing mode� The Wireless
Audio Indicator ( ) in the Status Bar will flash rapidly�
2. Press‑and‑hold the Multi Function Button (the centre
button) on the ML 105 headphones until the Status LED
flashes red and blue�
3. Your headphones will connect automatically — the
Wireless Audio Indicator (
remain On, and the LED on the headphones will flash
blue once every 3 seconds�
If no connection is made within 5 minutes, Wireless
Audio will automatically turn Off�
CONTENTS
"Wired Headphones" on
Minelab ML 105
Wireless Headphones�
) in the Status Bar will
RE-CONNECT PREVIOUSLY PAIRED
HEADPHONES
1. Press the Wireless Side Button (
2. Press the Multi Function Button (the centre button) on
the ML 105 headphones to turn them On�
3. The headphones will re‑connect automatically�

THE WIRELESS AUDIO INDICATOR

The Wireless icon appears in the Status Bar when Wireless
is On� It indicates the current Wireless connection status
depending on its display state�
Rapid flashing: Detector is attempting to pair�
ƒ
Solid on: Detector is connected to wireless headphones
ƒ
accompanied by the Headphones Connectivity icon�
Slow flashing: The detector is attempting to re‑connect
ƒ
with previously‑paired wireless headphones�
FACTORY RESET THE HEADPHONES
Refer to the instructions supplied with the headphones�
63
) to turn wireless On�