Attach The Armrest; Attach The Headphones; Disconnect The Coil - Minelab CTX 3030 Manual

6

Attach the Armrest

1. Thread the Velcro strap through the
armrest, with the Velcro side facing up.
2. Slide the armrest onto the rail on top of
the chassis. Ensure that the sloping sides
of the armrest face toward the control
panel.
3. Turn the armrest lock clockwise to fasten
the armrest in the desired position.
NOTE
To fit a smaller arm, the Velcro strap can be
fitted upside down and passed through the
armrest three times.

Attach the Headphones

1. Plug the headphone jack into the
headphone module located above the
battery compartment. The headphones
may be plugged or unplugged at any
time.

Disconnect the Coil

1. Reverse the steps in 'Attach the Control
Box' , 'Attach the Lower Shaft to the
Chassis' and 'Attach the Coil to the Lower
Shaft' .
2. Pull the coil cable out from inside the
lower shaft.
Do not attempt to completely remove
the shaft assembly while the coil cable is
still connected to the control box.