Global And Local Settings - Minelab EQUINOX 600 Instruction Manual

Contents

Global and Local Settings

When you are adjusting Settings and Advanced Settings, the icons of affected Detect
Modes will appear on the LCD.
Reset a Search Profile
Individual Search Profiles can easily be returned to their factory
preset settings. Only the local settings will be reset; any global
settings will remain in their last-use state.
1. Navigate to the Detect Mode Search Profile you wish to reset.
2. Press and hold the Detect Mode button for 5 seconds.
3. The Mode icon will flash, 'SP' will appear on the Target ID
Display, indicating that the Search Profile has been reset.
'SP' will appear on the Target ID Display when a
Detect Mode Search Profile is reset.
4. Release the Detect Mode button. There will be a rising
confirmation tone.
Global Settings
Adjustments to some Settings
and Advanced Settings are
Global. All Detect Mode
Search Profiles will be affected by
changes to the setting.
Global Settings e.g. Volume; All Detect Modes and
Search Profile icons are on.
Semi-Global Settings
For Semi-global Settings and
Advanced Settings, Park Field,
and Beach Mode Search
Profiles all have the same setting, and
Gold Mode Search Profiles have
another.
Semi-Global Settings e.g. Threshold Level; The Detect
Modes and Search Profiles affected by changes are
on.
Local Settings
Adjustments to some Settings
and Advanced Settings are
Local. Only the active Detect
Mode Search Profile will be affected by
changes to the setting.
Local Settings e.g. Recovery Speed; Only the Detect
Mode Search Profile affected by changes is on.
Global and Local Settings | 12
Global and Local Settings Reference
Frequency
Noise Cancel
Ground Balance
Volume Adjust
Tone Volume
Threshold Level
Threshold Pitch*
Target Tone
Tone Pitch
Accept/Reject
Tone Break
Recovery Speed
Iron Bias
Sensitivity
Backlight
Factory Reset the Detector
Factory Reset will return all detector settings and Detect Modes to
factory preset values, and will unpair all wireless headphones.
1. Turn the detector off.
2. Press and hold the Power button for approximately 8 seconds.
The start-up animation will display.
3. 'FP' will then appear on the Target ID Display, indicating that
Factory Presets are restored.
'FP' will appear on the Target ID Display when
Factory Presets are restored.
4. Release the Power button. There will be a rising confirmation
tone.
Local
Local
Local
Global
Local
Semi-global
Semi-global
Local
Local
Local
Local
Local
Local
Global
Global