Operation; Powerwasher Location; Checklistbefore Starting Engine; How To Start Your Powerwasher - Generac Power Systems 006022-0 Operator's Manual

IMPORTANT: Spray g untraps high water p ressure, even when
engine isstopped and water i sdisconnected.
:_
The highpressurestreamof water that this equipment
producescan cutthroughskinand its underlying
tissues,leadingto seriousinjury and possible
amputation.Spray guntraps high water pressure,even
when engineis stoppedand water is disconnected,
whichcan cause injury.
• Keep highpressure hoseconnected t o pumpandspraygunwhile
systemis pressurized.
• ALWAYS pointspray gun in safe direction,and squeeze spray
guntriggerto release highpressure, e verytime you stop engine.
Engage triggerlockwhennotin use.
OPERATION
If you haveany problemsoperatingyour power washer,pleasecall
Generaccustomer service at 1-888-436-3722.
POWER WASHER LOCATION
Clearances andAir Movement
Running enginegives off carbonmonoxide, a n
odorless,colorless,poisonous gas. Breathing carbon
monoxidecan causeheadache,fatigue, dizziness,
vomiting,confusion, s eizures,nausea,faintingor
death. For more information,reference the CO
warnings in the Safety Rules section.
Place power washer outdoors in an area that will not accumulate
deadly exhaust gas. NEVERplace power washer where exhaust
gas could accumulate and enter inside or be drawn into a
potentially occupied building. Ensure exhaust gas is kept away
from any windows, doors, ventilation intakes, or other openings
that can allow exhaustgasto collect in a confined area. Prevailing
winds and air currents should be taken into considerationwhen
positioning power washer (Figure20).
• Operate powerwasherONLY outdoors.
• Keep exhaust g asfrom entering a confined area throughwindows,
doors,ventilation intakes, o r otheropenings.
• NEVER startor run engine indoors or in anenclosed area,EVEN IF
windowsanddoorsareopen.
_ Exhaustheat/gases can ignite combustibles,
structuresor damage fuel tank causinga fire.
• Keepat least 5 ft. (152 cm) clearanceon all sides of power washer
including overhead.
Figure20 - Building Clearances
||i
5 Foot Minimum
CHECKLIST BEFORE STARTING E NGINE
1. Be sure to read and understandthe OperatorSafety section
and Operationsection before using power washer.
2. Check that oil is at the proper level in the engine crankcase
and that fuel has been added to the fuel tank.
3. Review the unit's assembly and ensure fitting are properly
secured and make surethere are no kinks, cuts, or damageto
high pressure hose.
4. Provide a proper water supply at an adequateflow, clear
screens of debris, and confirm that the system is purged of
air.
5. Confirm unit is secure on levelground and surroundingwork
area is clear.
HOW TO START YOUR POWER WASHER
NOTE:
DONOT run the pumpwithout the water supplyconnected
and turnedon. Damage to equipment resultingfrom failure to
follow this instruction will voidwarranty.
1. Move the fuel valve leverto the ON position (Figure21).
Figure 21 - Fue/ Va/ve
Off
11