Operation - Generac Power Systems 1540-0 Owner's Manual

5. Check to make sure there are no kinks, cuts, or
damage to high pressure hose.
6. Provide a proper water supply (not to exceed 100°F)
at an adequate flow.
7. Be sure to read "Safety Rules" and "How To Use Your
Pressure Washer" before using the pressure washer.
HOW TO USE PRESSURE
WASHER
If you have any problems operating your pressure washer,
please call the pressure washer helpline at
1-800-270-1408.
How to Start Engine
The best way to start your pressure washer for the first
time is to follow these instructions step–by–step. This
starting information also applies if you have let the it sit idle
for at least a day.
1. Place pressure washer near an outside water source
capable of supplying water at a flow rate greater than
5.0 gallons per minute and no less than 20 PSI at
pressure washer end of garden hose.
2. Make sure unit is in a level position.
3. Check that high pressure hose is connected to spray
gun and pump. See "Preparing Pressure Washer for
Use" for illustrations.
4. Connect garden hose to water inlet on pressure
washer pump. Turn ON the water.
5. Squeeze trigger on gun until you have a steady stream
of water. This purges pump of air and impurities.
CAUTION
DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
Generac Portable Products 3500 PSI Pressure Washer
6.
7.
8.
9.
NOTE: Always keep the Throttle Control lever in the
"Fast" position when operating the pressure washer.
How to Stop Pressure Washer
• Turn engine off according to instructions given in engine
• Squeeze trigger on the spray gun to relieve
NOTE: A small amount of water will squirt out when you
release the pressure.
8
Attach nozzle extension to spray gun. Tighten by hand
(Figure 4).
Figure 4 — Connect Nozzle Extension to Spray Gun
Apply safety latch to spray gun trigger (Figure 5).
Figure 5 — Spray Gun with Safety Latch Engaged
Select desired quick connect spray tip and insert it into
end of nozzle extension (see "How To Use Spray
Tips").
Start engine according to instructions given in engine
owner's manual.
CAUTION
Avoid injury from kickback.
• Squeeze trigger on spray gun each time recoil starter is
pulled and engine fails to start.
owner's manual.
pressure in the hose.
Safety Latch