Cleaningand Applying Detergent - Generac Power Systems 006022-0 Operator's Manual

Follow t hese i nstructions tochange nozzles:
1. Pull b ackcollar o nquick-connect andpullcurrent nozzles
off.Store n ozzles inholder provided ontheaccessory storage
(Figure 13).
Figure 13 - Nozzles
Formaximum rinsing (higherpressureandlower flow), for stubborn
or hard to reach surface such as second story surfaces, paint
removal, oil stains, rust removalor otherstubborn substances (tar,
gum, grease,wax, etc.), select red nozzle (Figure16).
_CAUTION!
,l& Thistip (Red Nozzle) can damage work surface if it is
too closeor held in one positionfor an extendedtime.
Figure 15- MaximumPressureNozzle (Red)
.
3.
Select desired nozzle:
Pull back on collar, insert new nozzle and releasecollar. Tug
on nozzleto make sure it is securelyin place.
• For delicaterinse (lowerpressureand higherflow), for gentle
cleaning of cars/trucks, boats, RV's, patio furniture, lawn
equipment, etc., selectwhitenozzle (Figure 14).
Figure 14- Low PressureNozzle (White)
• When applying detergent, use only the black nozzle (Figure17).
Onlyuse power washer safe detergents/soapsto help break down
stubborn dirt and grime on a variety of surfaces.
Figure 17 - Detergent Nozzle (Black)
• For generalrinsing (medium pressure and medium flow), idealfor
most all purposecleaning such as home siding, brick patios, wood
decks, driveways and sidewalks, garagefloors, etc., select yellow
nozzle (Figure15).
Figure 15- Medium Pressure Nozzle (Yellow)
CLEANING ANDAPPLYING DETERGENT
_,CAUTION!
,l& Chemicals can cause bodilyinjury,and/or property
damage.
• NEVER usecausticliquidwithpowerwasher.
• Use ONLYpower washer safe detergents/soaps. F ollow all
manufacturers instructions.
To apply detergent,follow these steps:
1. Reviewuse of nozzles.
2. Opencontainer cap (if so equipped,Figure18).
3. Preparedetergentsolution as required by job.