Download Table of Contents Print this page
Generac Power Systems 7132 Owner's Manual

Generac Power Systems 7132 Owner's Manual

Advertisement

Quick Links

SAVE THIS MANUAL FOR FUTURE REFERENCE
Power Washer
Owner's Manual
MODEL:________________________
MODEL:________________________
SERIAL:________________________
SERIAL:________________________
DATE PURCHASED:______________
DATE PURCHASED:______________
Register your Generac product at:
Register your Generac product at:
WWW.GENERAC.COM
WWW.GENERAC.COM
1-888-GENERAC
1-888-GENERAC
(1-888-436-3722)
006442

Advertisement

Table of Contents
loading

Summary of Contents for Generac Power Systems 7132

  • Page 1 Power Washer Owner’s Manual 006442 MODEL:________________________ MODEL:________________________ SERIAL:________________________ SERIAL:________________________ DATE PURCHASED:______________ DATE PURCHASED:______________ Register your Generac product at: Register your Generac product at: WWW.GENERAC.COM WWW.GENERAC.COM 1-888-GENERAC 1-888-GENERAC (1-888-436-3722) SAVE THIS MANUAL FOR FUTURE REFERENCE...
  • Page 2: Table Of Contents

    Table of Contents Section 1 Introduction and Safety 1 Power Washer Start-Up ....8 Introduction ........1 Power Washer Shut Down ....9 Safety Rules ........1 Apply Detergent .......9 Safety Symbols and Meanings ..2 Rinsing ..........9 Clean Detergent Siphoning Tube ..9 Section 2 General Information and Automatic Cool Down System Setup ..........
  • Page 3: Section 1 Introduction And Safety

    Introduction and Safety Section 1 Introduction and Safety Introduction Safety Rules The manufacturer cannot anticipate every possible circumstance that might involve a WARNING hazard. The warnings in this manual, and on Consult Manual. Read and understand manual tags and decals affixed to the unit are, there- completely before using product.
  • Page 4: Safety Symbols And Meanings

    Introduction and Safety Safety Symbols and Meanings WARNING Risk of Falling. Use of machine creates wet DANGER areas and trip hazards. Be aware of work area conditions. A fall could result in death Asphyxiation. Running engines produce or serious injury. carbon monoxide, a colorless, odorless, (000112) poisonous gas.
  • Page 5: Section 2 General Information And Setup

    General Information and Setup Section 2 General Information and Setup Know Your Power Washer Assembly WARNING WARNING Consult Manual. Read and understand manual Consult Manual. Read and understand manual completely before using product. Failure to completely before using product. Failure to completely understand manual and product completely understand manual and product could result in death or serious injury.
  • Page 6: Add Engine Oil

    General Information and Setup 3. See Figure 2-3. Install gun hook (A) on right (back) side of handle. Secure with tree clip (B). 000115 Figure 2-6. Remove Dipstick 4. Add recommended engine oil. 006459 NOTE: Some units have more than one oil fill Figure 2-3.
  • Page 7: Water Supply

    General Information and Setup 4. Slowly add recommended fuel. Do not Figure 2-9. Inspect Inlet Screen overfill. 4. See Figure 2-10. Connect water supply hose to pump water inlet and hand- tighten. 006443 Figure 2-8. Add Recommended Fuel 006216 5. Install fuel cap. Figure 2-10.
  • Page 8: Spray Gun

    General Information and Setup Blast Pressure Nozzle (Red) MAXIMUM - Higher pressure and lower flow for stubborn or hard to reach surface such as second story surfaces, paint removal, oil stains, rust removal or other stubborn substances (tar, gum, grease, wax, etc.). 001396 Clean Pressure Nozzle (Green) 000122...
  • Page 9: Section 3 Operation

    Operation Section 3 Operation Operation and Use Questions It is a violation of California Public Resource Code, Section 4442, to use or operate the Call Generac Customer Service at 1-888- engine on any forest-covered, brush-covered, GENERAC (1-888-436-3722) with questions or grass-covered land unless the exhaust concerns about unit...
  • Page 10: Electric Start

    Operation Electric Start Recoil Start NOTE: The battery must be installed before 1. Connect a sufficient water supply. Electric Start operation. For initial battery 2. Relieve spray gun pressure. installation, see Assembly. 3. Place foot on unit to secure unit from movement when pulling recoil.
  • Page 11: Power Washer Shut Down

    Operation Power Washer Shut Down NOTE: Verify siphoning tube and filter remain fully submerged in detergent while in use. NOTE: Detergent cannot be applied with high- WARNING pressure nozzle (White, Green or Red). Only Fluid Injection. This machine produces use black nozzle with detergent. high-pressure fluid streams that can pierce 4.
  • Page 12: After Each Use

    Operation After Each Use DO NOT allow water to remain in unit for long periods of time. Sediments or minerals can deposit on pump parts and freeze pump. Follow these procedures after every use: 1. Shut engine OFF. 2. Turn water supply OFF. 3.
  • Page 13: Section 4 Maintenance And Troubleshooting

    Maintenance and Troubleshooting Section 4 Maintenance and Troubleshooting Maintenance Pump Oil DO NOT attempt any oil maintenance on Regular maintenance will improve pump. Pump is lubricated and sealed at performance and extend engine/equipment factory. No additional maintenance is required life. Generac Power Systems,...
  • Page 14: Engine Maintenance

    Maintenance and Troubleshooting Engine Maintenance NOTE: Trigger should spring back into place and lock when released. Engine Oil Recommendations Nozzle Maintenance To maintain the product warranty, the engine A pulsing sensation felt when squeezing spray oil should be serviced in accordance with the gun trigger may be caused by excessive recommendations of this manual.
  • Page 15: Air Filter

    Maintenance and Troubleshooting Air Filter Engine will not run properly and may be damaged if run with a dirty air cleaner. Service air cleaner more frequently in dirty or dusty conditions. To service air cleaner: 1. Remove air cleaner cover. 2.
  • Page 16: Maintaining The Battery

    Maintenance and Troubleshooting Inspect Engine Spark WARNING Accidental Start-up. Disconnect spark plug wire when working on unit. Failure to do so could result in death or serious injury. (000102) 1. Disconnect spark plug wire from spark plug. 2. Secure spark plug wire where it cannot contact spark plug.
  • Page 17: Storage

    Maintenance and Troubleshooting 4. When battery is fully charged, the green • Replace fuel container if rust is present. “READY” LED will illuminate. Remove Rust in fuel will cause fuel system battery from charger. problems. • Cover unit with a suitable protective, NOTE: A completely discharged battery will moisture resistant cover.
  • Page 18 Maintenance and Troubleshooting 6. Disconnect hoses from spray gun and high-pressure outlet on pump. Drain water from hoses, spray gun, and lance. Use a rag to wipe off components. 7. Empty pump of all remaining liquids. 8. Pull recoil handle approximately six times to remove remaining liquid from pump.
  • Page 19 Maintenance and Troubleshooting Table 4-1. Troubleshooting Problem Cause Correction Pump fails to produce 1. Low pressure nozzle 1. Replace with high-pressure pressure, has erratic pressure, installed. nozzle. chattering, loss of pressure, 2. Water inlet is obstructed. 2. Clean inlet. low water volume. 3.
  • Page 20 ©2018 Generac Power Systems, Inc. All rights reserved Specifications are subject to change without notice. No reproduction allowed in any form without prior Generac Power Systems, Inc. written consent from Generac Power Systems, Inc. S45 W29290 Hwy. 59 Waukesha, WI 53189 1-888-GENERAC (1-888-436-3722) www.generac.com...

Table of Contents