Print Option Programming - Sam4s ER-420 Series Operation And Program Manual

Print Option Programming

Refer to the "Print Option Table" to review the print options. Read each option carefully to determine if you wish to
make any changes.
NOTE: Because after clearing memory all options settings are automatically set to 0, and
because your most likely option selections require a status setting of 0, you do not need to
program this section unless you wish to change the default status.
Programming a Print Option:
Print Option Flowchart
4
ER420 Series
1. Turn the control lock to the P position.
2. Enter 4 0, press the SBTL key.
3. Enter a print option address, press the X/TIME key.
4. Enter the number representing the status you have selected, or if there is more
than one decision to be made in an address, add the values representing your
choices for each decision and enter the sum. Press the SBTL key.
5. Repeat from step 3 for each print option you wish to change.
6. Press the CASH key to end print option programming.
0 SBTL
Option #
Repeat for each
Print Option
X/TIME SBTL
Status
Program Mode Programming • 95
CASH