Honeywell IPC5000 Installation Manual page 67

(4) ALARM ACTION : Selects alarm condition.
RUN : Alarm output enabled at 'RUN' mode.
ALL : Alarm output enabled at all time.
(5) ALARM Assign to : Selects channel for operation. It is available for IPC5000D.
(6) ALM ASSIGN : Registers the set alarm event to actual digital output number.
If the value is zero, the mode event is not assigned to a digital output. So To cancel the
assigning, set the value to zero.
Digital output number assigned by REGISTRATION number is same with Mode Event.
Refer to Table 3.11.2
(7) Data set part related to INNER alarm type.
(7-1) Event type number set
Sets event type number for OFF/ON operation of digital output. Event type number
can be set by Keypad directly or Up and Down arrow button.
Whenever Up and Down arrow button is pushed, (7-2) of figure 3.12.1 displays
operation description of the event type. So event type for operation can be selected.
Refer to Table 3.12.1 for Description by Event type number.
(7-2) Event type number description
Explains the operation of selected event type number.
Refer to Table 3.12.1 for more detail.
(7-3) Operation Point or Max value
The operation poiont for OFF/ON is changed according to event type number.
Refer to Table 3.12.1 and 2 for more detail.
(7-4) Differential or Min value
The operation poiont for OFF/ON is changed according to event type number.
Refer to Table 3.12.1 and 2 for more detail.
(7-5) Delay time
Sets delay time for OFF/ON.
Set range : 1 ~ 99 seconds
- 57 -