Table of Contents
Advertisement
Input type
K
J(IC)
R
Thermo
S
couple
B
E
T
N
W1
W2
C
If the button(4) is pushed, Figure 3.3.2 appears and you can select the sensor type
in the screen.
If the sensor type is changed, the PV and SP low/high limit range is adjusted
automatically according to the range of the selected sensor type.
(2-3) Dec. P. (decimal point) setup: Places Decimal point indication
Decimal point of Thermocouple and RTD type is 0 ~ 2, Default = 1
Volt and mA type is from 0 ~ 3, Default = 1
If the sensor type is changed, the decimal point is one.
(3) Sensor Select.
They are listed by sensor input type and setup range.
After pushing UP and DOWN arrow buttons and selecting the sensor type, if you push the "OK"
button, the sensor type is set and if you push the "CANCAL" button, it is canceled.
If you press the 'PAGE', 7 items of the sensor types are shown.
(4) SENSOR TYPE Setup Button: Screen switching
Switch to 'SENSOR SELECT' screen (Fig 3.3.2 ).
(5) SCALE LH(Low – High)
The high and low range of the Linear input type(Volt/Current) is set.
This set area is displayed, if the Volt/Current(0~10V, 0~5V, 1~5V, 0~20mA,
Input
Instrument input range
range
DEG C
code
K1
-200.0~200.0
K2
0.0 ~ 1200.0
K3
0.0~800.0
K4
0.0~400.0
K5
0.0~1316.0
J
0.0~800.0
R
0.0~1600.0
S
0.0~1600.0
B
0.0~1800.0
E
0.0~800.0
T
-200.0~300.0
N
0.0~1300.0
W1
0.0~1200.0
W2
0.0~2300.0
C
0.0~2300.0
- 31 -
DEG F
-328.0~392.0
32.0~2192.0
32.0~1472.0
32.0~752.0
32.0~2400.0
32.0~1472.0
32.0~2912.0
32.0~2912.0
32.0~3272.0
32.0~1472.0
-328~572.0
32~2372
32~2192.0
32~4172
32~4172
Advertisement
Table of Contents
