Honeywell IPC5000 Installation Manual page 30

9) Connection of Ethernet (Option)
IPC5000 is available for data monitoring or operating on touch operation panel as HMI or PC
software by 1:1 or 1:N through Ethernet port, Protocol should be used Modbus TCP only.
Setup of Ethernet port
The setup of Ethernet port can be set on '3.20 NETWORK SET' screen, the seting parameters are
as following table.
Parameter for setup of Ethernet port
Setting parameter
Protocol
FP Type
IP Address
GATE way
Sub net
Wiring
For Ethernet Communication, it should be used as followings.
Direct cable(PC to HUB)
Transmitt(TX)
Receiving(RX)
Crossover cable
- In case of connection PC into IPC5000.
Transmitt(TX)
Receiving(RX)
Range
Modbus TCP : Fixed
FPB, FPLB, FPBB, FPL
-
-
-
Output
Cable 1,2
Cable 3,6
Output
Cable 1,2
Cable 3,6
- 20 -
Remark
It is available for Universal Modbus only.
Default=192.168.0.2
Default =192.168.0.2
Default =255.255.255.0
Input
Cable 1,2
Cable 3,6
Input
Cable 3,6
Cable 1,2
Remark
Remark
Output
Input