Table 3.12.1 Alarm Event Flowchart - Honeywell IPC5000 Installation Manual

Table 3.12.1 Alarm Event Flowchart

Target
PV
Measured
Value
SP
Setting Value
MV
Output Value
Target
SP
Setting Value
DV
Segment Target Value
(NOTE 1) When setting the Max/Min value, the Max value should be greater than the Min one.
(NOTE 2) See the table 3.12.2 in the next page for details on Alarm event On/Off operation algorithm.
For Type number in IPC5000S, it is available for odd number.
Type Channel
11/12 CH1/CH2
CH1/CH2
13/14
CH1/CH2
15/16
CH1/CH2
17/18
CH1/CH2
21/22
CH1/CH2
23/24
31/32 CH1/CH2
33/34
CH1/CH2
Type Channel
CH1/CH2
25/26
CH1/CH2
27/28
CH1/CH2
31/32
CH1/CH2
33/34
Description OP point value
PV-ABS-LOW -19999~20000
PV-ABS-HIGH -19999~20000
PV-DEV-LOW -19999~20000
PV-DEV-LOW -19999~20000
SP-ABS-LOW -19999~20000
SP-ABS-HIGH -19999~20000
MV-ABS-LOW -5.0 ~ 105.0 %
MV-ABS-HIGH -5.0 ~ 105.0 %
Description Max Value
SP-DEV-OFF -19999~20000
SP-DEV-ON -19999~20000
DV-DEV-OFF -19999~20000
DV-DEV-ON -19999~20000
- 58 -
Differential
Delay Time
value
0~1000SPU 0~99sec
0~1000SPU 0~99sec
0~1000SPU 0~99sec
0~1000SPU 0~99sec
0~1000SPU 0~99sec
0~1000SPU 0~99sec
0.0 ~ 100.0 % 0~99sec
0.0 ~ 100.0 % 0~99sec
Min Value Delay Time
-19999~20000 0~99sec
-19999~20000 0~99sec
-19999~20000 0~99sec
-19999~20000 0~99sec