Mode Event Set Screen; Table 3.11.1 Mode Event Information; Fig. 3.11.1 Mode Event Set - Honeywell IPC5000 Installation Manual

3.11 MODE Event set screen

Return to Configuration
SET screen
(1)
(1) EVENT No. Display and Input
EVENT No. for setup(21 ~ 40)
The EVENT No. display to be set and buttons for input take place on the left. After this
button is pressed, use the keypad on the right pressing the 'ENT' key after the input
changes the value and it's saved, pressing 'ESC' key cancels the process.
(2) Changing EVENT No. for setup.
( + ) Increase : Whenever this button is pushed, the event No. increases by one.
( - ) Decrease : Whenever this button is pushed, the event No. decreases by one.
(3) EVENT Content Display
Highlighted according to 'EVENT No' configuration in (1) (See below Table).

Table 3.11.1 Mode Event information

ITEM
STOP
RUN
READY
END
TRBL
HOLD
WAIT
TUNE
EXIT
(3)
MODE
No
41
(2)
(4)
ASSIGN to
(5)
CONDITION
(6)
MODE ASSIGN
RANGE

Fig. 3.11.1 MODE EVENT SET

When Program STOP(Quit), ON
During RUN operating, ON
READY before operating the program, ON
When Program or Fix timer is completed and
the state is END, ON
When Trouble status occur, ON
When HOLD in process, ON
When the state us WAIT, ON
In Auto tuning, ON
MODE EVENT
RUN READY
STOP
END TRBL HOLD
WAIT TUNE MAN
FIX DOWN
CH1 CH2
AND
OR
3
OFFSET
MODE
Description
- 53 -
2003.01.23
12 H 59 M
UP
BOTH
ALARM
READY, END, BREAK,
TROUBLE = ON
HOLD, TUNE, WAIT =
ON
Remarks