Fig. 3.17.2 Fix Control Operation When Sp Tracking On And Jc = 2; Fig. 3.17.3 Fix Control Operation When Sp Tracking Off And Jc = 2 - Honeywell IPC5000 Installation Manual

Ramp is set by the
target setting value of
the fix control at the
last segment.

Fig. 3.17.2 Fix Control Operation when SP Tracking On and JC = 2

If SP tracking is OFF, the target setting value (SP) at the program end becomes the last target
setting value. The PV event runs as the event of the fix control and the time event is disabled.
Ramp is set by the
target setting value of
the fix control at the
last segment.

Fig. 3.17.3 Fix Control Operation when SP Tracking Off and JC = 2

(3) TIME UNIT setting button
Sets the default time unit of IPC5000.
HR.MIN: The minimum unit of the IPC5000 default time will be hour and minute.
MIN.SEC: The minimum unit of the IPC5000 default time will be minute and second.
PV
Last segment of
program operation
Time event
EVn
PV
Last segment of
program operation
Time event
EVn
Fix control
Fix control
- 72 -
SP tracking ON
Target setting value of fix control
Time
SP tracking OFF
Target setting value of fix control
Time