Nexxt Viking 150 User Manual page 40

Nexxt Solutions – Wireless-N 3G router
Select the desired wireless mode. When 802.11g mode is selected, only 802.11g wireless
stations can connect to the router. When 802.11n mode is selected, only 802.11n wire-
less stations can connect to the AP . It is strongly recommended that you set the Mode to
802.11b&g&n, and all of 802.11b, 802.11g, and 802.11n wireless stations can connect
to the router.
• Channel width - Select any channel width from the pull-down list. The default setting is auto-
matic, designed to instantly adjust the channel width of clients
Note: When 11b only, 11g only, or 11bg mixed is selected in the Mode field, the Channel
Width field will turn grey, showing a fixed setting of 20M, which remains unchanged.
Max Tx Rate – Use this field to limit the maximum Tx rate of the router.
•
• Enable wireless router radio - The wireless radio of this router can be enabled or disabled
to allow wireless stations access.
Enable SSID Broadcast – When wireless clients survey the local area for wireless networks
•
to associate with, they will detect the SSID broadcast by the router. If you select the Enable
SSID Broadcast checkbox, the wireless router will start broadcasting its name (SSID) over
the air.
• Enable WDS Bridging – Check this box to enable WDS Bridging. With this function, the
router can bridge two or more WLANs. If this checkbox is selected, you will have to set the
following parameters as shown below. Make sure the following settings are correct.
• SSID (to be bridged) - The SSID of the AP your router is going to connect to as a client.
You can also use the search function to select the SSID to join.
BSSID (to be bridged) - The BSSID of the AP your router is going to connect to as a client.
•
You can also use the search function to select the BSSID to join.
• Survey - Click this button, you can search the AP which runs in the current channel.
Key type - This option should be chosen according to the AP's security configuration. It is
•
recommended that the security type is the same as your AP's security type.
Figure 6-3
40