Nexxt Solutions – Wireless-N 3G router
Note: To build a successful connection via WPS, you should also configure the new device for
WPS in the meantime.
In order to configure the new device, we are going to use the Lynx Wireless Adapter from
Nexxt Solutions as an example.
I. PBC configuration
If the wireless adapter supports Wi-Fi Protected Setup and the Push Button Configuration
(PBC), you can add the device to the network by executing any of the two following methods.
First method:
Step 1: Click the Enable WPS button to trigger the WPS function in Figure 3-7, and click the
Add device button in Figure 3-7, then the following screen will appear.
Step 2: Choose Press the button of the new device in two minutes and click Connect.
Step 3: For the configuration of the wireless adapter, please choose Push the button on my
access point in the configuration utility of the WPS as below, and click Next.
Figure 3-8 The WPS Configuration Screen of Wireless Adapter
Figure 3-7 Add a new device
20