Table of Contents
Advertisement
Nexxt Solutions – Wireless-N 3G router
Location - Select the location where you're enjoying the 3G card.
•
•
Mobile ISP - Select the ISP (Internet Service Provider) you apply to for 3G service. The
router will show the default Dial Number and APN of that ISP .
•
Connect on Demand - You can configure the device to disconnect your Internet service
after a specified period of Internet inactivity (Max Idle Time). If your Internet connection has
been terminated due to inactivity, Connect on Demand enables the device to automatically
re-establish your connection as soon as you attempt to access the Internet again. If you
wish to activate Connect on Demand, check the corresponding radio button. If you want
your Internet connection to remain active all the time, enter 0 in the Max Idle Time field.
Otherwise, enter the number of minutes you want to have elapsed before your Internet
connection is terminated.
Note: Sometimes the connection cannot be terminated despite your setting a Max Idle Time.
This is due to some applications are continually linked to the internet in the background.
•
Connect Automatically - The connection can be re-established automatically after being
disabled. Check the radio button to enable this option.
Connect Manually - The device can be configured to be manually connected or
•
disconnected. After a specified period of inactivity (Max Idle Time), the device will disable
your Internet connection, without re-establishing your connection automatically once you
attempt to access the Internet again. To use this option, check the corresponding radio
button. If you want your Internet connection to remain active all the time, enter 0 in the
Max Idle Time field. Otherwise, enter the number of minutes you wish to keep the Internet
active, unless a new link requested.
Note: Sometimes the connection cannot be terminated despite your setting a Max Idle Time.
This is because some applications are continually linked to the internet in the background.
Authentication type - Some ISPs require a specific authentication type. Confirm this
•
information with your ISP or keep it in Auto mode. Three options are provided in this case.
•
Auto: The device automatically negotiates with the dialing server, so the type does not
need to be specified. Auto is the default type setting.
•
PAP: Password Authentication Protocol. This protocol allows the device to establish
authentication with the peer using two handshakes. Select this option if the ISP requires
this authentication type.
•
CHAP: Challenge Handshake Authentication Protocol. This protocol allows the router to
establish authentication with the peer using three handshakes and checking the peer
identity periodically. Select this option if the ISP requires this authentication type.
Click the Advanced settings button to set up the advanced options in the screen as shown in
Figure 3-19.
26
Hide quick links:
Advertisement
Table of Contents
