Nexxt Viking 150 User Manual page 32

Nexxt Solutions – Wireless-N 3G router
• Connect automatically - The connection can be re-established automatically after
being disabled.
Time-based connection - The connection will only be established within the period ranging
•
from the start time to the end time (both are in HH:MM format).
Note: The Time-based connection feature can work only after the system time on the
System Tools -> Time page has been configured.
• Connect manually - You can click the Connect/ Disconnect button to connect/discon-
nect immediately. This mode also supports the Max Idle Time function as the Connect on
Demand mode. The Internet connection can be disconnected automatically after a specified
•
period of inactivity, and re-established when you attempt to access the Internet once again.
Caution: Sometimes the connection cannot be terminated despite your setting of the "Max
Idle Time" interval. This is due to some applications are continually linked to the internet in the
background.
If you want to do some advanced configurations, please click the Advanced button, and the
page shown in Figure 3-25 will be displayed:
MTU Size - The default MTU size is "1480" bytes, which is usually fine. It is not recom-
•
mended that you change the default MTU Size, unless required by your ISP .
• Service Name/AC Name - The service name and AC (Access Concentrator) name, which
should not be configured unless you are sure it is necessary for your ISP . In most cases,
leaving these fields blank will work.
ISP Specified IP Address - If your ISP does not automatically assign IP addresses to the
•
router during login, please click Use IP address specified by ISP check box and enter the IP
address provided by your ISP in dotted-decimal notation.
Figure 3-25 PPPoE Advanced settings
32