Filter Flush - Zip HydroTap G4 Celsius Installation Instructions Manual

The HydroTap G4 Celsius is now ready to be commissioned.
®
• Turn the electrical power on at the mains and the Command-Centre
• Turn the gas and water on and check for any leaks.
• Familiarise yourself with the operation of the HydroTap
guide).
• Follow the installation instructions below (and review section C of the user guide).
• After commissioning, the system may be customised by selecting further options in section G -
Settings, of the user guide.
Purge (for chilled sparkling models)
6.1 - CO
2
Note
At first commissioning, the system will select the CO
[START] button to commence the purging process then follow the steps after [START] below.
Zip Chilled Sparkling
10.30 Wed 14, Nov 2013
Zip Chilled Sparkling

6.2 - Filter flush

Note
At first commissioning, the system will select the filter flush screen automatically after CO
Have a bucket or similar container (not supplied) at the ready to hold a quantity of water that will be ejected
while the filter flush mode is in operation. Open the filter access door on the front of the HydroTap
Celsius and the filter cartridge will be exposed. Located to the rear right hand side of the cartridge is a flush
line, approx 600mm long and the flush line stop cock. Place the free end of the flush line into the bucket or
container (not supplied).
Page 22 of 28
Section 6
Commissioning
Commissioning
10.30 Wed 14, Nov 2013
G4 Celsius in preparation for use (see user
®
purge automatically, in this instance press the
2
• Press the [MENU] button for main menu.
• Press the [Install] button.
• Press the [Purge CO] button.
• In the next screen, press the [START]
button to commence the purging process.
• You will hear the CO
the tap.
• Run for 10 seconds to fully purge the CO
• Press the [STOP] button to stop the purge.
• Press [Next] for filter flush screen.
802149UK Celsius residential - Installation instructions -Jan 2016 v2.03
ON / OFF switch.
TM
gas running through
2
purge.
2
.
2
G4
®