Cisco ASR 9000 Series Software Manual page 64

Configuring Multicast VPN
Command or Action
Step 5
router {igmp | mld}
Example:
RP/0/RSP0/CPU0:router(config)# router igmp
Step 6
nsf lifetime seconds
Example:
RP/0/RSP0/CPU0:router(config-igmp)# nsf lifetime
30
Step 7
commit
Step 8 show {igmp nsf
Example:
RP/0/RSP0/CPU0:router# show igmp nsf
Step 9 show mfib [ipv4 | ipv6] nsf [location node-id]
Example:
RP/0/RSP0/CPU0:router# show mfib nsf
Step 10 show mrib [ipv4 | ipv6] nsf
Example:
RP/0/RSP0/CPU0:router# show mrib nsf
Step 11 show pim [ipv4 | ipv6] nsf
Example:
RP/0/RSP0/CPU0:router# show pim nsf
Configuring Multicast VPN
•
• "Configuring BGP to Advertise VRF Routes for Multicast VPN from PE to PE" (required)
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 5.1.x
64
Enabling a VPN for Multicast Routing, on page 66
See the module "Implementing BGP on Cisco IOS XR Software in Cisco ASR 9000 Series Aggregation
Services Router Routing Configuration Guide.
Implementing Layer-3 Multicast Routing on Cisco IOS XR Software
Purpose
(Optional) Enters router IGMP or MLD configuration mode.
(Optional) Configures the NSF timeout value for multicast
forwarding route entries under the IGMP process.
(Optional) Displays the state of NSF operation in IGMP.
(Optional) Displays the state of NSF operation for the MFIB
line cards.
(Optional) Displays the state of NSF operation in the MRIB.
(Optional) Displays the state of NSF operation for PIM.
(required)