Cisco ASR 9000 Series Software Manual page 111

Implementing Layer-3 Multicast Routing on Cisco IOS XR Software
Associating a route policy to PIM configuration for the VRF receiving IGMP
reports
SUMMARY STEPS
1. configure
2. router pim vrf vrf-name address-family ipv4
3. rpf-topology route-policy policy-name
4. commit
DETAILED STEPS
Command or Action
Step 1 configure
Step 2 router pim vrf vrf-name address-family ipv4
Step 3 rpf-topology route-policy policy-name
Example:
RP/0/RSP0/CPU0:router(config-rpl)# rpf-topology
extranet-igmp-reports
Step 4
commit
Configuration Examples for Implementing Multicast Routing on
Software
This section provides the following configuration examples:
Calculating Rates per Route: Example
The following example illustrates output from hardware counters based on rate per route for a specific source
and group address location:
RP/0/RSP0/CPU0:router#
RP/0/RSP0/CPU0:router(config)#
RP/0/RSP0/CPU0:router(config-mcast-default-ipv4)#
RP/0/RSP0/CPU0:router(config-mcast-default-ipv4)#
RP/0/RSP0/CPU0:router(config-mcast-default-ipv4)#
RP/0/RSP0/CPU0:router(config-mcast-default-ipv4)#
RP/0/RSP0/CPU0:router(config-mcast-default-ipv4)#
Associating a route policy to PIM configuration for the VRF receiving IGMP reports
configure
multicast-routing vrf vpn12 address-family ipv4
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 5.1.x
Purpose
Enters PIM address-family IPv4 submode.
Associates a previously defined route-policy with
the non-default VRF that receives the IGMP reports.
rate-per-route
interface all enable
accounting per-prefix
commit
exit
111