Cisco ASR 9000 Series Software Manual page 107

Implementing Layer-3 Multicast Routing on Cisco IOS XR Software
Command or Action
Step 4
core-tree-protocol rsvp-te group-list name
Example:
RP/0/RSP0/CPU0:router(config-mcast-default-ipv4)#
core-tree-protocol rsvp-te group-list acl1
Step 5
commit
Configuring IGMP VRF Override
This process consists of the following tasks:
Specifying VRF definition
SUMMARY STEPS
1. configure
2. vrf vrf-name
3. address-family ipv4 unicast
4. import route-target 1:1
5. export route-target 1:1
6. commit
DETAILED STEPS
Command or Action
Step 1 configure
Step 2 vrf vrf-name
Example:
RP/0/RSP0/CPU0:router(config)# vrf name1
Step 3
address-family ipv4 unicast
Example:
RP/0/RSP0/CPU0:router(config-vrf)# address-family ipv4
unicast
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 5.1.x
Configuring IGMP VRF Override
Purpose
Enters the core-tree-protocol configuration
mode.
Purpose
Enters the VRF configuration sub mode.
AFI configuration for IPv4. This is supported
on unicast topologies only.
107