Cisco ASR 9000 Series Software Manual page 115

Implementing Layer-3 Multicast Routing on Cisco IOS XR Software
This end-to-end configuration example shows how to establish a multicast VPN topology
in CE4PE1PE2 CE3MVPN Configuration, on page
BGP) to broadcasting traffic between customer-edge(CE) routers and provider-edge (PE) routers:
Figure 11: Topology in CE4PE1PE2 CE3MVPN Configuration
CE4------------------ PE1 ------------------------------------------------ PE2 ------------------ CE3
For more configuration information, see the
related configuration information in Cisco ASR 9000 Series Aggregation Services Router Routing Configuration
Guide .
Configuring MVPN to Advertise Routes Between the CE and the PE Using OSPF: Example
PE1:
!
vrf vpn1
address-family ipv4 unicast
import route-target
1:1
!
export route-target
1:1
!
!
!
interface Loopback0
ipv4 address 1.1.1.1 255.255.255.255
!
interface Loopback1
vrf vpn1
ipv4 address 2.2.2.2 255.255.255.255
!
interface GigabitEthernet0/5/0/0
vrf vpn1
ipv4 address 101.1.1.1 255.255.255.0
!
interface TenGigE0/6/0/0
ipv4 address 12.1.1.1 255.255.255.0
!
mpls ldp
router-id 1.1.1.1
interface TenGigE0/6/0/0
!
!
multicast-routing
vrf vpn1 address-family ipv4
mdt data 233.1.0.0/16 threshold 3
mdt default ipv4 232.1.1.1
rate-per-route
interface all enable
accounting per-prefix
!
address-family ipv4
nsf
mdt source Loopback0
interface all enable
accounting per-prefix
!
!
router bgp 100
bgp router-id 1.1.1.1
address-family ipv4 unicast
!
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 5.1.x
Configuring IPv4 Multicast VPN: Example
115), using two different routing protocols (OSPF or
Configuring Multicast VPN, on page 64
(Figure 11: Topology
of this module and also
115