Cisco ASR 9000 Series Software Manual page 37

Implementing Layer-3 Multicast Routing on Cisco IOS XR Software
Profile
Number
9
LSP-switch for P2MP-TE
Turnaround for P2MP-TE can be handled by LSP-switch with a partitioned profile. For partitioned profiles,
there is no core tree (where all the PEs join). When the traffic arrives at the ingress PE, it is forwarded to the
RP-PE on a LSP. The RP-PE must then switch the traffic to a different LSP for all the non-RP PE receivers.
Configuration Process for MLDP MVPN (Intranet)
These steps provide a broad outline of the different configuration process of MLDP MVPN for intranet:
Note For detailed summary of the various MVPN profiles, see the
page 36.
• Enabling MPLS MLDP
• Configuring a VRF entry
• Configuring VPN ID
The configuring VPN ID procedure is needed for profiles 1 and 9 (Rosen MLDP).
• Configuring MVPN Routing and Forwarding instance
Label Switched Multicast (LSM) Multicast Label Distribution Protocol (mLDP) based Multicast VPN (mVPN) Support
Name Opaque-value
Rosen MLDP with Type 2 -
BGP -AD RootAddresss:VPN -
ID:0 -n
◦ configure
◦ mpls ldp mldp
◦ configure
◦ vrf vrf_name
◦ address-family ipv4/ipv6 unicast
◦ import route-target route-target-ext-community
◦ export route-target route-target-ext-community
◦ configure
◦ vrf vrf_name
◦ vpn id vpn_id
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 5.1.x
BGP-AD Data-MDT
PIM or BGP-AD
• Intra-AS MI- PMSI
(knob controlled)
• S- PMSI for
Data-MDT
Summary of Supported MVPN Profiles, on
37