Initial Power Up - ETC Irideon FPZ User Manual

Initial Power Up

Track-Mount, Portable, and Canopy (DMX) Fixtures
Control and configure the fixture over a DMX/RDM control network or directly
from a connected computer running appropriate software. When controlling
the fixture directly from a PC, a Gadget II interface or DMX/RDM gateway is
required.
Note: Changing the address via RDM will override the local
Canopy (0–10V) Fixture
Apply power and dim the fixture using a 0–10V controller.
Note: The 0–10V driver conforms to IEC 60929 Annex E. Of the
Canopy (DALI) Fixture
Use a DALI configuration and commissioning tool to configure the DALI
address of the fixture.
Status LED
The status LED indicates the DMX status. When DMX is present, the LED turns
on for 10 seconds, and then it turns off.
Note: A change to the DMX start address, the local intensity, or
When the local intensity is set to Off, the status LED will flash when there is a
loss of DMX.
With the local intensity set to any other position, the status LED will flash for
10 seconds when there is a loss of DMX. Then the LED will turn off.
18
DMX addressing dials. However, if you change the
addressing dials after you set the address via RDM, the
addressing dials will override the RDM setting. See
DMX Address on the Fixture
0–10V range, use 0–1V to set the minimum level, and use
1–10V for continuous dimming.
the presence of DMX will "wake" the status LED.
on
page 15.
Set the
FPZ