Retrofit The Fixture; Wire The Power Connector - ETC Source 4WRD Color Quick Manual

ETC Quick Guide
Source 4WRD Color (CE) Version 1.0.0
WARNING:
•
•
•
•
•
•

Retrofit the Fixture

WARNING:
Source 4WRD Color retrofit kit requires knowledge of luminaire
electrical systems. If you are not qualified, do not attempt
installation. Contact a qualified electrician.
Note:
LUMINAIRE WHERE THE SUITABILITY OF THE COMBINATION SHALL BE
DETERMINED BY AUTHORITIES HAVING JURISDICTION.

Wire the Power Connector

If you ordered a Source 4WRD Color retrofit without a power connector, wire
the connector in accordance with all national and local electrical codes:
Brown = Live
•
Blue = Neutral
•
Green/Yellow = Protective earth
•
Source 4WRD Color (CE)
Note the following safety warnings before use:
The Source 4WRD Color is not user serviceable. Field
modification of the Source 4WRD Color will void your ETC
warranty.
Do not use the fixture below 5°C (41°F).
Minimum storage temperature is 5°C (41°F). When the
fixture has been stored or transported in cold
temperatures, allow it to warm to room temperature for
a minimum of 1 hour before applying power. Applying
power to a cold fixture will cause damage to the fixture
and void the ETC warranty.
Do not use this fixture if a glass lens is deeply scratched or
cracked. Damaged lenses must be replaced.
To prevent wiring damage, or abrasion, do not expose
wiring to edges of sheet metal or other sharp objects.
Use the fixture in dry locations only, where humidity does
not exceed 90 percent (non-condensing). These fixtures
are not intended for outdoor use.
RISK OF FIRE OR ELECTRIC SHOCK! Installing the
THE RETROFIT KIT IS ACCEPTABLE AS A COMPONENT OF A
Page 2 of 8 ETC