Camera Type Codes - Photon Focus MV3-D640I-M01-144-G2-12 User Manual

9.7.3 Camera Type Codes

Table 9.5: Type codes of Photonfocus MV3-D640-M01 GigE cameras series
9.8 Test Images
Test images are generated in the camera FPGA, independent of the image sensor. They can be
used to check the transmission path from the camera to the frame grabber. Independent from
the configured grey level resolution, every possible grey level appears the same number of
times in a test image. Therefore, the histogram of the received image must be flat.
A test image is a useful tool to find data transmission errors that are caused most
often by a defective cable between camera and frame grabber.
The analysis of the test images with a histogram tool gives the correct result at a
resolution of 512 x 512 pixels only.
9.8.1 Ramp
Depending on the configured grey level resolution, the ramp test image outputs a constant
pattern with increasing grey level from the left to the right side (see Fig. 9.20).
Figure 9.20: Ramp test images: 8 bit output (left), 10 bit output (middle),12 (right)
9.8.2 LFSR
The LFSR (linear feedback shift register) test image outputs a constant pattern with a
pseudo-random grey level sequence containing every possible grey level that is repeated for
every row. The LFSR test pattern was chosen because it leads to a very high data toggling rate,
which stresses the interface electronic and the cable connection.
In the histogram you can see that the number of pixels of all grey values are the same.
MAN076 09/2017 V1.0
Camera Model
MV3-D640I-M01-144-G2-12
Camera Type Code
502
9.8 Test Images
73 of 121