Camera Type Codes; Test Images; Ramp - Photon Focus MV1-R1280-50 Series User Manual

5.7.3 Camera Type Codes

Table 5.6: Type codes of Photonfocus MV1-R1280 GigE camera series

5.8 Test Images

Test images are generated in the camera FPGA, independent of the image sensor. They can be
used to check the transmission path from the camera to the acquisition software. Independent
from the configured grey level resolution, every possible grey level appears the same number
of times in a test image. Therefore, the histogram of the received image must be flat.
A test image is a useful tool to find data transmission errors or errors in the access
of the image buffers by the acquisition software.
The analysis of the test images with a histogram tool gives gives a flat histogram
only if the image width is a multiple of 1024 (in 10 bit or 12 bit mode) or 256 (in
8 bit mode). The height should be a multiple of 1024 In 12 bit mode.

5.8.1 Ramp

Depending on the configured grey level resolution, the ramp test image outputs a constant
pattern with increasing grey level from the left to the right side (see Fig. 5.21).
Figure 5.21: Ramp test images: 8 bit (left), 10 bit (middle), 12 bit (right) at a resolution of 1024x1024 pixels
Implementation details:
8 bit: Every row has the same data. The leftmost pixel has the value 0 and then the value is
incremented by 1 on every subsequent pixel up to a value of 255. After 255 the next pixel
has the value 0 and the sequence is repeated.
10 bit: Every row has the same data. The leftmost pixel has the value 0 and then the value is
incremented by 1 on every subsequent pixel up to a value of 1023. After 1023 the next
pixel has the value 0 and the sequence is repeated.
MAN066 12/2018 V1.1
Camera Model
MV1-R1280-50-G2-16
Camera Type Code
470
5.8 Test Images
57 of 103