JUKI DDL-9000C-F Instruction Manual page 130

8-9-2. USB
(1) About the USB
Sewing data, custom pitch data and condensation custom data can be copied on a commercially-available
USB thumb drive.
"8-9-1. Data communication" p.123
Refer to
drive.
① Position of the USB connector
② Precautions to be taken when handling USB devices
• Do not connect to the USB connection terminal other than the USB memory.
It may cause failure.
• Do not leave the USB device or USB cable connected to the USB port while the sewing machine is in
operation. The machine vibration can damage the port section resulting in loss of data stored on the
USB device or breakage of the USB device or sewing machine.
• Do not insert/remove a USB device during reading a program or sewing data.
It may cause data breakage or malfunction.
• When the storage space of a USB device is partitioned, only one partition is accessible.
• Never forcefully insert a USB thumb drive into the USB connector while carefully checking the orienta-
tion of the USB thumb drive. Forceful insertion of the USB thumb drive can cause failure.
• JUKI does not compensate for loss of data stored on the USB device caused by using it with this sewing
machine.
• In principle, connect only one USB thumb drive to the operation panel. When two or more devices/media
are connected/inserted, the machine will only recognize one of them. Refer to the USB specifications.
• Do not turn the power OFF while the data on the USB flash drive is being accessed.
③ USB specifications
• Conform to USB 1.1 standard
• Applicable devices * 1 ���� USB memory
• Format supported ������ FAT 12, FAT 16, FAT 32
• Applicable medium size �� 4.1MB ~ (2TB)
• Consumption current ���� The rated consumption current of the applicable USB devices is 500 mA at
* 1 : JUKI does not guarantee operation of all applicable devices. Some device may not operate due to a
compatibility problem.
for details of how to copy the sewing data on a USB thumb
❷
❶
the maximum.
– 126 –
[USB thumb drive insertion position]
The USB connector is provided on top ❶ of the
operation panel.
To use a USB thumb drive, remove connector
cover ❷ and insert the USB thumb drive into the
USB connector.
* In the case a USB thumb drive is not used,
the USB connector should be protected with
connector cover ❷ without exceptions.
If dust or the like enters the USB connector, a
failure can be caused.