Handling The Cords - JUKI DDL-9000C-F Instruction Manual

2-8. Handling the cords

DANGER :
1. To prevent personal injuries caused by electric shock hazards or abrupt start of the sewing
machine, carry out the work after turning OFF the power switch and a lapse of 5 minutes or more.
2. To prevent accidents caused by unaccustomed work or electric shock, request the electric expert
or engineer of our dealers when adjusting the electrical components.
❷
A
❹
2-9. Attaching the connecting rod
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and a lapse of 5 minutes or more.
❶
B A
❶
❸
❷
❸
❹
1) Bring the cords under the table into the control
box.
2) Put the cord brought into the control box through
cord exit plate ❶ and fix cable clip band ❷.
Arrange the cord so that it is not tensed
or hitched even when the machine head
is tilted. (See A section.)
3) Install control box cover ❸ with four setscrews ❹.
For the purpose of preventing the cord
breakage, take care not to allow the
cords to be caught between the control
box and control box cover ❸ when
attaching the latter.
1) Fix connecting rod ❶ to installing hole B of pedal
lever ❷ with nut ❸.
2) Installing connecting rod ❶ to installing hole A
will lengthen the pedal depressing stroke, and the
pedal operation at a medium speed will be easier.
3) The pressure increases as you turn reverse de-
pressing regulator screw ❹ in, and decreases as
you turn the screw out.
1. If the screw is excessively loosened,
the spring will come off. Loosen the
screw to such an extent that the top
of the screw can be observed from
❺
the case.
2. Whenever you have adjusted the
screw, be sure to secure the screw by
tightening metal nut ❺ to prevent the
screw from loosening.
– 9 –