Reverse Feed Stitching (At End) Pattern - JUKI DDL-9000C-F Instruction Manual

4-2-7. Reverse feed stitching (at end) pattern

A stitch shape of reverse feed stitching (at end) is set by following the steps of procedure described
below.
(1) Enabling the reverse feed stitching (at end) pattern
❶
In the case the reverse feed stitching or double reverse feed stitching is selected, number of stitches A
is displayed on the left side and number of stitches B is displayed on the right side on
the case the condensation stitching is selected, only number of stitches A is displayed on
range: 0 to 99). In the case the condensation custom is selected, the condensation custom number is
displayed on .
(2) Changing the number of stitches and pitch of reverse feed stitching (at end) pattern
① Displaying the edit screen for reverse feed stitching (at end)
❶
② Setting the shape, the number of stitches and pitch of reverse feed stitching (at end)
❷
❹
<Sewing-end reverse feed stitching edit screen>
❷ ❸
– 47 –
The sewing-end reverse feed stitching pat-
tern can be operated when the sewing-end
reverse feed stitching function is placed in
the ON state ( mark is not displayed).
If this function is placed in the OFF state press
the sewing end reverse feed stitch button to
switch off mark display to enable the sew-
ing-end reverse feed stitching function.
❶ held pressed for one sec-
Keep
ond. The reverse feed stitching (at end) edit
screen is displayed.
Change the numeric value with
The value you have entered is confirmed by
❸ . Then, the sewing screen
pressing
is displayed.
❹ to select the type of sew-
Press
ing.
❶ , and in
(display
❷ .