Table of Contents
Advertisement
2-15 Handling the cords
DANGER :
1. To prevent personal injuries caused by electric shock hazards or abrupt start of the sewing machine,
carry out the work after turning OFF the power switch and a lapse of 5 minutes or more.
2. To prevent accidents caused by unaccustomed work or electric shock, request the electric expert or
engineer of our dealers when adjusting the electrical components.
2-15-1. Handling the cords coming from the control box
❷
A
2-15-2. Handling the cords coming from the control box for stitch skipping detecting device
❺
❶
❸
❹
❸
❹
❻
❷
1)
Bring the cords under the table into the control
box.
2)
Put the cord brought into the control box through
cord exit plate ❶ and fix cable clip band ❷ .
Arrange the cord so that it is not tensed
or hitched even when the machine head is
tilted. (See A section.)
Install control box cover ❸ with four setscrews
3)
❹ .
For the purpose of preventing the cord
breakage, take care not to allow the cords to
be caught between the control box and con-
trol box cover ❸ when attaching the latter.
Fix cord ❷ coming from control box ❶ for the
1)
stitch skipping detecting device and tube ❸
coming from the solenoid valve to the table with
accessory cable clip ❹ and wood screw ❺ as
illustrated in the figure.
In addition, fasten cord ❷ and tube ❸ with ac-
cessory two 10 mm long cable clip bands ❻ as
illustrated in the figure.
– 18 –
Advertisement
Table of Contents
