Table of Contents
Advertisement
Keysight InfiniiVision 2000/3000 X-Series Oscilloscope
Service Guide
4 Troubleshooting
Solving General Problems with the Oscilloscope / 64
Verifying Basic Operation / 66
Read All Cautions and Warnings
Before you begin any troubleshooting, read all Warning and Cautions in the "Troubleshooting" section.
This chapter begins with
you what to do in these cases:
•
If there is no
•
If there is no trace
•
If the trace display is unusual or
•
If you cannot see a
Next, this chapter describes procedures for
oscilloscope:
•
To power-on the
•
To perform hardware self
•
To perform front panel self
•
To verify default
•
To perform an Auto Scale on the Probe Comp
•
To compensate passive
The service policy for all 2000/3000 X-Series oscilloscopes is now unit
replacement, so there are no longer internal assembly troubleshooting
instructions in this service guide.
"Solving General Problems with the
display.
display.
unexpected.
channel.
oscilloscope.
test.
test.
setup.
probes.
Oscilloscope. It tells
"Verifying Basic Operation
signal.
of the
63
Advertisement
Table of Contents
Need help?
Do you have a question about the InfiniiVision 2000 and is the answer not in the manual?