Turn Extending Table Character On/Off; Turn On/Off Ocrb Selection - Printronix P7000 H-Series Programmer's Reference Manual

Chapter 3
Configuring The KSSM Emulation With Control Codes

Turn Extending Table Character On/Off

ASCII Code FS v n
Hex Code
Dec Code
Purpose
Comment

Turn On/Off OCRB Selection

ASCII Code ASSC 0 z n
Hex Code
Dec Code
Purpose
Comment
78
1C 76 n
28 118 n
Turns on/off extending table characters, as follows:
n = 0 or 48Cancels extending table characters
n = 1 or 49Selects extending table characters
Where:
n = 0, 1, 48, 49
This command extends the table characters so they touch in
both horizontal and vertical directions.
The limitation of extension is ½ inch.
Our printer could extend the table characters in the range of
A6A1H to A6E4H in the Hangul Complete font.
The default is Table Character not extended.
ASSC 30 7A n
ASSC 48 122 n
Turns on/off OCRB selection as follows:
n = 0 or 48Turns off OCRB selection
n = 1 or 49Turns on OCRB selection
Where:
n = 0, 1, 48, 49
When OCRB selection is turned on, the OCRB character can
be printed out.
This command affects the front panel setting of "OCRB
Selection."
This command works only in DBCS mode.
The default is n = 0.