Chapter
3
Configuring The KSSM Emulation With Control Codes
Reassign Bit-image Mode
ASCII Code ESC ? n m
Hex Code
Dec Code
Purpose
Comment
Select 1/6-inch Line Spacing
ASCII Code ESC 2
Hex Code
Dec Code
Purpose
Comment
Select 1/8-inch Line Spacing
ASCII Code ESC 0
Hex Code
Dec Code
Purpose
Comment
50
1B 3F n m
27 63 n m
Assigns the dot density used during the ESC K, ESC L, ESC Y,
or ESC Z commands to the density specified by parameter m in
the ESC * command.
Where:
n = 75, 76, 89, 90
0 <= m <= 40
The default settings are as follows:
ESC K is assigned density 0
ESC L is assigned density 1
ESC Y is assigned density 2
ESC Z is assigned density 3
1B 32
27 50
Sets the line spacing to 1/6 inch.
Changing the line spacing does not affect previous settings for
vertical tabs or page length.
This command affects the front panel setting of "Select LPI."
1B 30
27 48
Sets the line spacing to 1/8 inch.
Changing the line spacing does not affect previous settings for
vertical tabs or page length.
This command affects the front panel setting of "Select LPI."