Select Character Table
ASCII Code ESC t n
Hex Code
1B 74 n
Dec Code
27 116 n
Purpose
Selects the character table to be used for printing among the
two character tables described below:
n = 0 or 48
Character table 0
n = 1 or 49
Character table 1
Where:
0 <= n <= 1, 48 <= n <= 49
Currently, the setting on the front panel of "Alt. Set 80-9F"
determines whether n = 0 would be treated as Control Code or
Printable Code. Thus, this determines the setting n = 1.
Comment
This command affects the front panel setting of "Character Set."
Select Condensed Printing
ASCII Code SI
Hex Code
0F
Dec Code
15
Purpose
Enters condensed mode, in which character width is reduced
as follows:
Selected pitch
10 cpi
12 cpi
Proportional
Comment
This command is ignored under the following two conditions:
15-cpi printing has been selected with the ESC g command.
This command reduces character width by about 50% when
proportional spacing is selected with the ESC p command.
Cancel condensed printing with the DC2 command.
This command only takes effect in SBCS mode.
The default is Non-condensed printing.
Select Character Table
0x80-0x9f Control code, 0xa0-0xff Italic
0x80-0xff Printable code, IBM PC437
Condensed pitch
17.14 cpi
20 cpi
½ width
57