Set Dbcs Character Half Width; Cancel Dbcs Character Half Width And Super/Subscript Printing; Set Horizontal Tabs - Printronix P7000 H-Series Programmer's Reference Manual

Chapter 3
Configuring The KSSM Emulation With Control Codes

Set DBCS Character Half Width

ASCII Code FS SI
Hex Code
Dec Code
Purpose
Comment
Cancel DBCS Character Half Width and
Super/Subscript Printing
ASCII Code FS DC2
Hex Code
Dec Code
Purpose
Comment

Set Horizontal Tabs

ASCII Code ESC D n
Hex Code
Dec Code
Purpose
Comment
68
28 0F
1C 15
Prints DBCS characters that follow at about half their normal
width, and SBCS characters maintain their normal width.
Use the FS DC2 command to cancel half-width DBCS
character printing.
This command resets subscript/ superscript printing set by the
FS r command.
The default is Normal (non half-width) printing.
28 12
1C 18
This command cancels the FS SI (half-width DBCS character)
and FS r (set super/subscript printing) commands.
The default is Normal (non half-width and non-super/subscript)
printing.
n ... n NUL
1 2 k
1B 44 n n ... n 00
1 2 k
27 68 n n ... n 00
1 2 k
Sets horizontal tab positions (in the current character pitch) at
the columns specified by n
margin position.
The values for n must be in ascending order; a value of n less
than the previous n ends tab setting (like the NUL code).
Where:
0 <= k <= 32
1 <= n <= 255
n > n
k k-1
Changing the character pitch does not affect current tab
settings.
Send an ESC D NUL command to cancel all tab settings.
The tab settings move to match any movement in the left
margin.
to n as measured from the left-
1 k