Font Attributes; Graphics Spd Up - Printronix P7000 H-Series Programmer's Reference Manual

Font Attributes

This submenu allows you to define the following font attributes: typeface, bold
print, and italic print. You can also specify if the ASCII character will print with
the OCRB mode. Also, specify if the zero character will print with a slash.
When High Density is enabled, the LQ Typeface will print in higher print
density. It will not take effect when other typefaces are selected.
Text position specifies where the text will be positioned in the line space.
When set to Top of Line, text will be positioned at the top of the line space.
When set to Bottom of Line, the text will be positioned as if it were at the
bottom of a 6 lpi line space. The following example shows both Top of Line
and Bottom of Line text positions:
Dot
Row
Top of Linespace
1
2
3
4
5
6
7
8
Bottom of 8 LPI Linespace
9
10
11
Bottom of 6 LPI Linespace 12
The option "DBCS/ASCII Mode" specifies the operating mode of the Hangul
printer. If it is set to DBCS mode, it can print double-byte characters as well as
a limited number of single-byte characters.
The option "Address Table" specifies the address table supported: KSC5601.
The option "UTF8" allows the user to input UTF8 data stream.
The option "Taller 15cpi" specifies the appearance of ASCII character in 15cpi
in Ascii mode. If it is set to "Enable", the characters in 15cpi will be the same
height with other CPIs like 10cpi. If it is set to "Disable", the characters in
15cpi will appear shorter than other CPIs like 10cpi.
The option "Horizontal Expnd" specifies the character horizontal expansion in
dot for both ASCII and DBCS characters in DBCS mode.
The option "Vertical Expnd" specifies the character vertical expansion in dot
for both ASCII and DBCS characters in DBCS mode.

Graphics Spd Up

This menu is used to increase (speed up) graphic printing speed by turning on
the Enhanced/Turbo mode.
•
Normal. The default. The printer prints at the given input graphics
resolution.
•
Enhanced. The printer provides first-level speed up, which means the
speed is faster than Normal mode.
Text Position
Top of Line Bottom of Line
LinePrinter Plus Menu
1
Text Position
23