Advance Print Position Vertically; Align Sbcs Character With Dbcs Character - Printronix P7000 H-Series Programmer's Reference Manual

Chapter 3
Configuring The KSSM Emulation With Control Codes
FUNCTION
Hangul Extension Commands (continued)
Turn Extending Table Character
On/Off
Turn Underline On/Off
Superset Command
Barcode Printing
Graphics Printing: Select Bit Image
Turn On/Off OCRB Printing
Define User Defined Character
Font Expansion
Graphic Printing
Master Select One-Line Attribute

Advance Print Position Vertically

ASCII Code ESC J n
Hex Code
Dec Code
Purpose
Comment

Align SBCS Character with DBCS Character

ASCII Code FS U
Hex Code
Dec Code
Purpose
Comment
34
1B 4A n
27 74 n
Advances the vertical print position n/180 inch.
Where:
0 <= n <= 255
This command does not affect the horizontal print position.
Advances paper to the top-of-form position on the next page if
the ESC J command moves the print position below the
bottom-margin position setting.
28 85
1C 55
Aligns two SBCS characters to fit the space normally occupied
by a full-width DBCS character that does not have a half-width,
subscript, or superscript feature.
A DBCS character with half-width, subscript, or superscript
feature is treated as an SBCS character.
The intercharacter space of the next character is set by the FS
S command.
In the default mode, the SBCS character aligns with the DBCS
character.
ASCII CODE
FS v n
FS - n
SSCC c t
SSCC * m nL nH d1 ... dk
ASSC 0 z n
ASSC 0 2
ASSC 0 e
ASSC 0 *
ASSC 0 !
PAGE
78
80
36
45
78
40
43
44
49