Chapter
3
Configuring The KSSM Emulation With Control Codes
Divided Hangul Double Height
ASCII Code FS X n
Hex Code
Dec Code
Purpose
Comment
Enable Printing of Upper Control Codes
ASCII Code ESC 6
Hex Code
Dec Code
Purpose
Comment
42
28 58 n
1C 88 n
Turns on/off divided double height printing of all characters as
follows:
n = 0
Turns off divided double height
n = 1
Double height upper part of character
n = 2
Double height lower part of character
n = 3
Double height whole character
Where:
0 <= n <= 3
The line spacing of the line with upper part double height (set
by FS X 1) will change to 24/180 inch.
The baseline of the line including double-height characters (set
by FS X 3) moves down 24/180 inch, and the line spacing also
increases 24/180 inch.
The default is Normal (non double-width double-height)
printing.
1B 36
27 54
Tells the printer to treat codes 128 to 159 as printable
characters instead of control codes.
This command affects the front panel setting of "Alt. Set 80-9F."
This command works in ASCII mode only.
In the default mode, codes 128 to 159 are treated as printable
characters.