Table of Contents
Advertisement
Before Cleaning
Before cleaning the printer, turn the printer off and unplug the power cord.
Unload the paper (page 3–12), and perform the following steps. (refer to the
maintenance manual for further assistance).
NOTE: If you must move the printer, follow instructions in the next section
1.
Fully raise the forms thickness adjustment lever.
2.
Unlatch both ribbon spools, and carefully lift them off the hub. Raise the
ribbon out of the ribbon path.
3.
Remove the shuttle cover by grasping the cover on both sides. Lift it up
at the rear, while gently sliding it backward and off the shuttle.
Routine Service and Diagnostics
on Moving the Printer.
Forms-
Thickness
Adjustment
Lever
Ribbon Path
9–3
Advertisement
Table of Contents
