Printronix MVP Series User Manual page 77

Options 31–41 — Control Code Assignments
Discussion
Eleven configuration options are included in this group. When the control
code assigned to a specific configuration option appears in the data stream,
the printer will operate in response to the selection in that configuration
option. For example, if Option 31.0 is selected and ESC ! appears in the data
stream, the printer will switch to Text Dump Mode.
150B/L150B
Option Display
Number
.0
.1
.0
.1
.0
.1
.0
.1
.0
.1
Configuration
Option 31
Control Code Assignment – 01 Hex
31.0 Escape (ESC or SOH) sequences: ESC ! for Text Dump Mode,
ESC P for Mode 1, and ESC R for Mode 2. (default)
31.1 Escape (ESC or SOH) sequences: ESC ! for master print mode,
ESC P for ignored, and ESC R for ignored.
Option 32 *
Control Code Assignment – Cedilla Character Select
32.0 Extended character address 128 produces a space.
32.1 Extended character address 128 produces the Cedilla character
(Default).
* This configuration is available only on printers equipped with
V50.59 DCU, MCU 20.25 (or later) firmware, and primary font
PROM 116043–001 or equivalent.
Option 33
Control Code Assignment
33.0 Slash zero disable (default).
33.1 Slash zero enable.
Option 34
Control Code Assignment – Alternate Printronix Plot Control
34.0 Enable ESC Y, even dot centers. (default)
34.1 Ignore ESC Y.
Option 35
Control Code Assignment – Alternate Printronix Plot Control
35.0 Enable ESC Z, odd dot centers (default).
35.1 Ignore ESC Z.
4–25