Printronix MVP Series User Manual page 227

Check
Indicator
Flashing
Flashing
Flashing
Flashing
Steady
Steady
Steady
All switch
indicators On
or Off
Clear Check Condition
After all faults are corrected:
1. Press CHK to clear the fault condition (CHK indicator will go out).
2. If applicable, press RDY to place the printer on–line.
B–2
Table B–1. Fault Code Chart
Fault Fault
Code Description
011 No paper
012 Forms thickness lever
open; shuttle assembly
cover off or out of place.
014 Shuttle jam
015 Shuttle not up to speed
030 Printer memory:
031 checksum or pattern
032 check. These are "soft"
040 faults.
033
041
050
051
060 Power supply: +30/+12
voltage failure
061 Power supply: –16/–12
voltage failure
None Data processor
malfunction
Corrective
Action
Load paper
Close lever; replace or reseat
shuttle cover.
Remove jammed paper or
straighten ribbon.
Remove any jammed paper;
straighten ribbon; or check that
forms thickness lever is in cor-
rect position.
None, but can be bypassed. Keep
a log of these codes and when
they occur for your field service
representative.
None. Call an authorized service
representative.
None. Call an authorized service
representative.
None. Call an authorized service
representative.
Appendix