Printronix MVP Series User Manual page 129

0CH — Top–of–Form/Perforation Skip
Control code 0CH causes the contents of the print buffer to be printed, and
follows up with a top–of–form or a perforation skip operation.
With Configuration Option 50
You can set the length of the Perforation Skip by using Configuration Option
50 for one of four lengths. Configuration Option 50 can also be set to disable
Perforation Skip.
NOTE: Before you power up, make sure the paper supply is properly loaded
Programming
with its top–of–form set correctly. If necessary, adjust the top–of
form.
7–5