Customer Commands - Comtech EF Data TRP1000-OD Installation And Operation Manual

5.5

Customer Commands

Command
Parameter (Instruction
Type Code and
or Response
Qualifier)
Auto Fault AFR= 1 byte
Recovery
RF Power
AMP= 1 byte
Amplifier
State
Amplifier APM= 1 byte
Power-up
Mode
Serial-based Remote Product Management
Arguments
for Description of Arguments
Command (Note that all arguments are ASCII
numeric codes between 48 and 57)
to Query
Command or Query.
Sets the automatic fault recovery mute mode.
Where:
1 = Automatic fault recovery enabled (unit will automatically
return to its pre-fault mute state after all fault conditions
clear)
0 = Automatic fault recovery disabled (unit will remain
muted until the user un-mutes the output using the MUT
command)
Example:
<0001/AFR=1'cr'
>0001/AFR='cr''lf'
Default Value: 1
Command or Query.
Turns ON or OFF the RF power amplifiers.
0 = Off
1 = On
Example:
<1/AMP=1'cr'
>0001/AMP='cr''lf'
Default Value: 0
Command or Query.
Enables or disables the amplifier power-up mode.
0 = Disabled. Amplifier is always off at power-up.
1 = Enabled. Amplifier is set to the last user configured state
at power-up (on or off depending on the AMP setting).
Example:
<1/APM=1'cr'
>0001/APM='cr''lf'
Default Value: 0
TRP1000-4450 Troposcatter C-Band Outdoor Amplifier
Response to
Command
(Target to
Controller)
AFR=
AFR?
AMP=
AMP?
AMP*
APM=
APM?
APM*
5–10
Revision 0
Query Response
(Instruction to Query
Code and (Target to
Qualifier) Controller)
AFR? AFR=x
(Same
format as
command
arguments)
AMP? AMP=x
(Same
format as
command
arguments)
APM? APM=x
(Same
format as
command
arguments)
MN-TRP1000-OD