Module Leds; Fiber Optic Cables; Installation - Thinklogical VTM-004200 Product Manual

High reliability, rack-space saving, video and audio extension solutions, velocitykvm, t-series modular kvm extension solutions

Hide thumbs Also See for VTM-004200:

Table of Contents

thinklogical

2.3 Module LEDs

Both the Transmitter and Receiver Modules feature five LEDs. Their functions are as follows:

2.4 Fiber Optic Cable

Fiber optic cables connect the Transmitters to the Receivers. Standard multi-mode fiber optic cables

must be 50 or 62.5 microns, terminated with LC type fiber optic connectors. Be careful not to kink or

pinch the fiber optic cable as it is being installed and keep all bend diameters to no less than 3

inches (76.2mm).

◄Receive

◄Transmit

Standard multi-mode fiber optic cable (up to 1000 meters),

50 or 62.5 microns, terminated with LC-type connectors

With two fibers connected (in models with one SFP) or with three fibers connected (in models with two

SFPs) video information is transmitted from the TX to the RX over fiber L1 (and L3 in models with two

SFPs). Fiber L2 is used as a data return path from the RX to the TX, allowing full duplex, bi-directional

RS-232 data transfer.

All physical connections to the product use industry-standard connectors. Non-supplied cables are

commercially available. All connections are found on the rear of the unit.

T-Series DVI Modules, Rev. G

October, 2016

Table of Contents

Vtm-q04200