Installation Prerequisites - SpectraLink IP-DECT Server 400 Installation And Configuration Manual

Spectralink IP-DECT Server 400/6500 Installation and Configuration Guide

Installation Prerequisites

Note:
Ensure that a site survey and deployment have been conducted and that the installer has-
access to these plans before proceeding any further. For more information, see Syn-
chronization and Deployment Guide.
Before you start the installation, you need to find the following information and perform the following
tasks:
ARI codes (serial numbers) for the Spectralink IP-DECT Server (see label on the rear of the
l
server unit)
For more information, see
Serial numbers for handsets.
l
For more information, see
AC codes (authentication codes)
l
The AC is a customer-defined optional subscription pin code of a maximum of eight digits for
the individual handset. The AC can be used when connecting the handset to the server.
Repeaters:
l
Mark each repeater with the number of the related base station. This way you can easily con-
figure the system on site.
Handsets:
l
To use the handsets, you must first install the radio infrastructure, e.g. base stations and
repeaters to transmit and receive radio signals to and from the handsets. There are no direct
connections between the handset and the system.
Charging battery
l
When charging the handset battery for the first time, leave the handset in the charger for 14 -
16 hours to ensure that the battery is fully charged and the handset ready for use. For more
information about the handset, refer to the user guide available online at
port.spectralink.com/products.
14215700-IG, Edition 7.0
January 2018, Original document
"Identifying ARI on Spectralink IP-DECT Server" on the next
"Identifying IPEI on Spectralink Handset" on the next
page.
page.
http://sup-
37