Restarting System Or Block Calls During Firmware Update; To Restart System Or Block New Calls; Reading System Information - SpectraLink IP-DECT Server 400 Installation And Configuration Manual

Spectralink IP-DECT Server 400/6500 Installation and Configuration Guide
Restarting System or Block Calls during Firmware
Update
Through the web based Administration Page of the Spectralink IP-DECT Server it is possible to
restart he Spectralink IP-DECT Server or block new calls during firmware update..

To Restart System or Block New Calls

1. Click Administration, and then click Wireless Server.
2. On the Wireless Server page, under Wireless Server Status, click Reboot now or
Reboot when idle (when active calls have ended) if you want to restart the system.
3. On the Wireless Server page, under Service Status, click Block if you want to block for
new calls during firmware update.
4. Click OK again.

Reading System Information

Through the web based Administration Page of the Spectralink IP-DECT Server it is possible to
read the following system information:
General status
l
Logs Information
l
Wireless Server Information
l
Statistics (Wireless Server, Media Resource, Base Station, Active Calls, Abnormal Releases,
l
Traffic Distribution)
14215700-IG, Edition 7.0
January 2018, Original document
133