LifeSpan C5i Owner's Manual page 23

Assembling Your C5i Upright Bike
Step 7: Handlebar Assembly
A. Place bike upright on all four feet.
B. Align the Handlebar Assembly (8) with the Handlebar Bracket (H) on the
Console Mast (7).
C. Feed the wire harness connector from the top of the Console Mast (7)
through the square hole in the middle of the Handlebar Assembly (8).
There should be four wire connectors coming out the top of the
Handlebar Assembly.
Place the Handlebar Assembly (8) into the Handlebar Bracket (H) and
D.
align with bolt holes. Be sure to pull any slack wiring through the Han-
dlebar Assembly so the wire harness does not get pinched.
E. Install two M8 Bolts (20) through the Handlebar Assembly (8) into the
Handlebar Bracket (H).
F. Securely tighten bolts.
26
8
H
7
20